DIY Creepy Crepe Paper Corpse Roses

It’s hard to resist a little bit of the macabre when it comes to Halloween décor, and these DIY crepe paper corpse roses fit the bill perfectly. Whip out a bouquet in just a few minutes, and you’ll have the final touch for this year’s Halloween decorations. Be warned, though: these get addicting to make. You might not want to stop once you get the hang of it…and four dozen black roses might be a little much, even for Halloween.

View in gallery

View in gallery

Materials Needed:

  • Black crepe paper
  • Floral wire
  • Wire cutters or tin snips
  • Double-sided tape
  • Scissors
  • Vase

View in gallery

Begin by measuring and folding over your floral wire at about 9”. If your vase is much taller than this, adjust the measurement accordingly – aim for 2”-4” taller than the lip of your vase.

View in gallery

Snip the wire so the two ends are even.

View in gallery

Casually twist the wire together. This isn’t a big deal and won’t even be seen, but it helps to give the flower stem more stability while not disturbing the other stems.

View in gallery

Place a piece of double-sided tape at the top end of your wire, about 1” long and running lengthwise.

View in gallery

Set the edge of your crepe paper on the tape, with about 1/2″ of the crepe paper sticking above the end of your wire, and begin rolling it tightly.

View in gallery

Roll about four to six round of crepe paper pretty tightly to form the innermost “bud” of your rose.

View in gallery

Begin loosening the roll, bunching up the bottom inner crepe paper while leaving more and more crepe paper out on top as the rose petals. Add a short bit of double-sided tape outside your pinched crepe paper, and cover this with the paper as you twist and pinch it to the wire. Move slowly down the stem as you twist.

View in gallery

Keep the inner part of the crepe paper (the part attached to the wire) pinched together as you continue rolling. When the rose looks like it’s about the size you want, snip the end of your crepe paper about 4” off.

View in gallery

Twist the crepe paper around the wire for that last little bit.

View in gallery

Pinch the paper against the wire tightly.

View in gallery

Add a short (1/2”) length of double-sided tape to the bottom of your pinched crepe paper. Cut a slim end off of the crepe paper.

View in gallery

Wrap this slim crepe paper sliver around the double-sided tape to hold everything in place and finish off your rose.

View in gallery

Add the rose to your vase, and start on the next one. Some of them might look better than others; don’t worry too much about each individual rose. When they’re all combined into a bouquet, the effect is eerily lovely.

View in gallery

The inner part of these roses is my favorite; how they move from such tight petals to more spacious ones.

View in gallery

They definitely look creepy, all in a deathly black bouquet.

View in gallery

This vase is just getting started. We don’t want to offend the bride of Frankenstein.

View in gallery

Happy DIYing your own creepy black crepe paper roses!

Powered by WPeMatico

Antiques

AdSense